Assembly Instructions-Spirol Lok Models
After all components are clean and dry, place the filter element back in the case making sure the three “ears” on the element fall into their slots in the case. Next, reference the spirol lok installation below. (Note: The top (upper) ring of the spirol lok has a bent tip.)
Hold the bottom (lower) spirol lok ring in your right hand with the bottom end to your left.
Insert the very bottom END of the spirol lok into the slot in the housing.
With your right thumb on the top side of that bottom ring and your forefinger under that bottom ring, tip the top of the spirol lok toward you (like a cup of coffee) while pushing the spirol lok down into the slot in the housing. Do not try to thread or spin the spirol lok in, the key is the tipping motion of your right hand while pushing down to get it to snap in.
Continue this technique until the spirol lok is completely installed into the slot in the housing.
